Toro 132-6960 Installation Instructions

Led lamp kit greensmaster 3000 series traction unit with light kit

Download this manual

LED Lamp Kit

Greensmaster

Model No. 132-6960

Note: This kit replaces standard lights with LED lights. A light kit must already be installed on the machine.

This product contains a chemical or chemicals known to the State of California to

Installing the Kit

1. Park the machine on a level surface, turn off the engine,

and remove the key.

CAUTION

If you leave the key in the ignition switch,

someone could accidently start the engine and

seriously injure you or bystanders.

Remove the key from the ignition switch

before you do any maintenance.

2. Disconnect the negative ( - ) battery cable from the

battery.

3. Disconnect the existing lamp from the wiring harness.

8111 Lyndale Avenue South

Bloomington, MN 55420

3000 Series Traction Unit with Light Kit

WARNING

CALIFORNIA

Proposition 65 Warning

cause cancer, birth defects, or reproductive harm.

4. Remove the existing carriage bolt, nut, and lamp from

the support bracket

(Figure

Figure 1

1. Lamp

2. Carriage bolt

Original Instructions (EN)

Printed in the USA

Form No. 3396-562 Rev A

Installation Instructions

1).

3. Support bracket

4. Nut

Page 1 Form No. 3396-562 Rev A LED Lamp Kit Greensmaster ® 3000 Series Traction Unit with Light Kit Model No. 132-6960 Installation Instructions Note: This kit replaces standard lights with LED lights. A light kit must already be installed on the machine. WARNING CALIFORNIA...
Page 2 5. Install the LED lamp to the support bracket using a 6. Connect the kit wiring harness to the LED lamp carriage bolt, lockwasher, and nut (Figure (Figure Figure 3 1. Kit wiring harness 2. Existing wiring harness Figure 2 7.