Panasonic LP-RF Series Setup & Maintenance Manual page 197

Troubles
For communication
command control:
"reception mode ON"
is set for command
reception permission (MKM
command).
Marking ready does
not turn ON.
For LP-RC/LP-RF/LP-RV
series:
Counter has been reset
during On-the-fly marking
operation.
The requested operation can
be controlled only by I/O with
the current system settings.
"Reception mode ON"
is not set for command
reception permission (MKM
command).
The sending
command is not
accepted and
negative response is
returned.
Alarm or Warning occurred.
Causes
Set "reception mode OFF" for command reception permission
(MKM command).
Once the counter is reset during On-the-fly marking operation,
READY OUT becomes OFF temporarily and may not accept the
trigger. Please check the counter reset timing.
To use the following commands, specify the control method
to the communication command in Laser Marker NAVI smart
system settings and restart the laser marker.
• Laser pumping (LSR)
• Shutter open/close (SHT)
• Guide Laser (GID) (except LP-GS052 type)
The following commands are available only when the shutter
open/close control method is set to communication command.
• Laser radiation for measurement (SPT)
Except the following commands *, the laser marker cannot
accept the setting request commands unless it is in the "reception
mode ON" status. For command transmission, set "reception
mode ON" by MKM command.
• File selection by number (FNO)
• File selection by name (FNN)
• Shutter open/close (SHT)
• Command reception permission (MKM)
• Laser pumping (LSR)
• Counter reset (CTR)
• Marking trigger (MRK)
• Character entry per trigger (SIN)
• Marking position and laser power adjustment per trigger (SEO)
All commands except the following commands * cannot be
accepted while alarm or error is active.
When alarm occurred:
• Status checking (STS)
• I/O monitor (IOM)
• Operating data (RTD)
• Error history (ERH)
• Alarm reset (ARS)
• Error code (ENO)
When warning occurred:
• Status checking (STS)
• I/O monitor (IOM)
• Operating data (RTD)
• Error history (ERH)
• Alarm reset (ARS)
• Error code (ENO)
• Shutter open/close (SHT) (Only closing and readout request)
• Command reception permission (MKM) (readout only)
ME-LPRF-SM-11
Measures
197