Related Manuals for Toro 66100 Series
Summary of Contents for Toro 66100 Series
- Page 1 Form No. 3445-340 Rev A Revolution 60V Backpack and Blower Cannon Tool Model No. 66100—Serial No. 323000001 and Up Model No. 66100T—Serial No. 323000001 and Up *3445-340* Register at www.Toro.com. Original Instructions (EN)
- Page 2 The backpack is designed to provide power to compatible Toro 60V handheld tools. It is designed to use Toro 60V lithium-ion battery packs. These battery packs are designed to be charged only by Toro 60V lithium-ion battery chargers.
-
Page 3: Safety Alert Symbol
II. Preparation Keep bystanders and children away from the operating area. Use only the battery pack specified by Toro. Using other accessories and attachments may increase the risk of injury and fire. Plugging the battery charger into an outlet that is not 120 V can cause a fire or electric shock. - Page 4 Charge the battery pack with only the battery power tool will do the job better and safer at the charger specified by Toro. A charger suitable for rate for which it was designed. 1 type of battery pack may create a risk of fire Do not overreach—Keep proper footing and...
- Page 5 before adjusting, servicing, cleaning, or storing the backpack or tool. Check the tool and backpack for damaged parts—If there are damaged guards or other parts, determine whether it will operate properly. Check for misaligned and binding moving parts, broken parts, mounting, and any other condition that may affect its operation.
-
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal145-2316 decal145-2315 145-2316 145-2315 1. Warning—read the 3. Thrown object 1. - Page 7 decal145-3809 145-3809 1. The battery pack is over 2. Battery pack charging or under the appropriate fault. temperature range. decal145-2317 145-2317 1. Battery charge status...
- Page 8 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Blower cannon Middle tube section Assemble the blower tubes. Nozzle section Backpack Install the blower cannon. Blower cannon assembly Assembling the Blower Tubes Slide the channels of the middle blower tube section over the posts on the blower tube cylinder, and rotate the middle section to secure it (A of Figure...
-
Page 9: Product Overview
Installing the Blower Product Overview Cannon to the Backpack Note: The backpack can also be used to power other tools using the backpack tether Model 66005 (not included). Align the blower cannon with the backpack power connection (Figure g366972 Figure 6 1. -
Page 10: Specifications
Contact your Authorized Service Dealer or authorized Toro distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. - Page 11 Pull down on the shoulder strap adjuster until the straps are snug (Figure 11). g377912 Figure 9 1. Sternum strap adjuster 3. Hip belt adjuster and and buckle buckle g377918 Figure 11 2. Shoulder strap adjuster Connect and adjust the height of the sternum Tighten the sternum strap so that it is snug strap.
- Page 12 Adjusting the Blower Grip If the hip belt is too tight, push sideways on the adjuster to lengthen the straps (Figure 14). Position The blower grip position is adjustable; while wearing the backpack, do the following: Loosen the blower grip knob by turning it counterclockwise.
-
Page 13: Starting The Blower
Starting the Blower Set the backpack down on a level surface. Pull up on the latch tabs to open the latches securing the battery cover and set the cover WARNING aside. The blower can throw debris, possibly Line up the cavity on the back of the battery with causing serious personal injury to you or either of the battery ports in the backpack. - Page 14 Shutting Off the Blower To start the blower, squeeze the variable-speed trigger (Figure 20). To shut off the blower, disengage the speed lock (if in Note: Engage the speed lock to keep the use) and release the variable-speed trigger (Figure machine on without pressing the variable-speed 21).
- Page 15 Removing the Batteries Removing the Blower from the Backpack Cannon from the Backpack Set the backpack down on a level surface. Press the blower latch button and pull up on the blower cannon to separate it from the backpack (Figure 23).
- Page 16 Storage Important: Store the tool, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 10). Important: If you are storing the battery pack for the off-season, remove the battery pack from the tool and charge the battery pack until 2 or 3 LED indicators turn green on the battery.
-
Page 17: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action An LED indicator light on the backpack is 1. - Page 18 Notes:...
- Page 19 California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.