Confirmation Of Route Information - Hitachi GR4000 Series Quick Start Manual

GR4000 Quick Start Guide, Revision 1 - Preliminary

4.2 Confirmation of Route Information

This section describes how to check route information.
All the commands introduced here can be used in the mode of general users.
When executing commands, you can use the function of simplifying command inputs.
For details, see the section "6.1 Convenient Functions".
(1) Display of routing tables
You can show a list of all routing tables.
GR1> show ip route
Total: 106 routes
Destination
0.0.0.0/0
127/8
127.0.0.1/32
172.16.178/25
172.16.178.21/32
192.168.20/24
192.168.30/24
GR1>
NOTE The example above is for the case where RIP and Static are used as routing protocols.
(2) Display of RIP gateway (sender of RIP packets) information
You can confirm the sender of RIP packets.
show ip rip gateway
GR1>
Gateway Address Age
192.168.50.185 1s
192.168.60.30 14s
192.168.70.30 9s
GR1>
NOTE The example above is for the case where RIP is used as a routing protocols.
40
Next Hop Interface
172.16.178.114 Office1
---- localhost
127.0.0.1 localhost
172.16.178.21 Office1
172.16.178.21 Office1
172.16.101.115 Office2
172.16.101.115 Office2
172.16.171.116 Office3
Flags
<Accept>
< >
<Accept>
...The route information will be shown.
Metric Protocol Age
0/0 Static 365d
0/0 Static 365d
0/0 Direct 365d
:
0/0 Direct 365d
0/0 Direct 365d
3/0 RIP 5s
0/0 Static 90d 20h
- - -
...The RIP gateway infromation will be shown.
QSGGR4K00-10 5794047-1X