Confirmation Of Route Information - Hitachi GS4000 Series Quick Start Manual

6.3 Confirmation of Route Information

6.3 Confirmation of Route Information
This section describes how to check route information.
The commands introduced here can be used in the mode of both general users and administrators. When executing commands,
you can use the function of simplifying command inputs. For details, see the section "8.1 Convenient Functions".
(1) Display of routing tables
You can show a list of all routing tables
show ip route
GS1>
Total: 6 routes
Destination
127/8
127.0.0.1/32
192.168.1/24
192.168.1.1/32
192.168.2/24
192.168.2.1/32
GS1>
NOTE The example above is for the case where RIP and Static are used as routing protocols.
(2) Display of RIP gateway information
You can confirm the sender of RIP packets.
show ip rip gateway
GS1>
Gateway Address Age
192.168.50.185
192.168.60.30
192.168.70.30
GS1>
NOTE The example above is for the case where RIP is used as a routing protocols.
QSGGS4KX10-00 5794092-2X
Next Hop Interface
---- localhost
127.0.0.1 localhost
192.168.1.1 VLAN100
192.168.1.1 VLAN100
192.168.2.1 VLAN200
192.168.2.1 VLAN200
Flags
1s <Accept>
14s < >
9s <Accept>
...The route information will be shown.
Metric Protocol Age
0/0 Direct 55m 44s
0/0 Direct 55m 44s
0/0 Direct 4m 23s
0/0 Direct 4m 23s
0/0 Direct 14m 9s
0/0 Direct 14m 9s
...The RIP gateway infromation will be shown.
GS4000 Quick Start Guide, Revision 3
53