Unpacking And Initial Startup; Unpacking And Inspection - GE PACSystems RXi Box IPC User Manual

Unpacking and Initial Startup

Chapter
2
This chapter contains information you need to perform a pre-installation check of your RXi Box
IPC.
Before installing and using the IPC, the following steps should be completed.

Unpacking and Inspection

Upon receiving your RXi Box IPC, carefully inspect all shipping containers for damage. If any part
of the system is damaged, notify the carrier immediately. The damaged shipping container should
be saved as evidence for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for damage
incurred during shipment. However, we will fully cooperate with you, should such action be
necessary.
After unpacking the Box IPC, record all serial numbers. Serial numbers are required if you
need to contact Customer Care during the warranty period. All shipping containers and all
packing material should be saved should it be necessary to transport or ship any part of the
system.
Verify that all components of the system have been received and that they agree with your
order. If the system received does not agree with your order, contact Customer Care. If you
need technical help, contact Technical Support. For phone numbers and email addresses, see
the "Contact Information" page in the front of this manual.
Before you attempt to power up the IPC for the first time, inspect the unit for loose or damaged
components. If damage is observed (for example, in the form of bent component leads or loose
components), contact GE Intelligent Platforms for additional instructions. Depending on the
severity of the damage, it may be necessary to return the product to the factory for repair.
Do not apply power to the unit if it has visible damage. Applying power to a unit with damaged
components may cause additional damage.
GFK-2785C

Unpacking and Inspection

Initial Startup

Configuring Ethernet Communications
PACSystems* RXi Box IPC 7