Uhd Dtl - Panasonic AK-HRP1010G Operating Instructions Manual

UHD DTL

The control destination differs depending on the unit configuration.
When the camera is an AK-UC4000 or AK-UC3300
The control is performed for the camera.
When the camera is other than the above
The control is performed for the CCU.
The setting values will vary also depending on the connected camera.
Items with the function disabled are indicated by "-".
For details on each setting item, check also the operating instructions of the camera and CCU to be connected.
Item
M.DTL Adjusts the level of master detail.
H DTL LEVEL Adjusts the level of horizontal detail.
V DTL LEVEL Adjusts the level of vertical detail.
PEAK FRQ Selects the contour correction frequency band (boost frequency or peak frequency). Changes the contour
width.
CRISP Set the noise elimination level for the detail signals.
CLIP+ Adjusts detail clipping to minimize scintillation resulting from excessive detail application.
CLIP- This limits the length of the undershoot portion of the detail edge component.
KNEE APERTURE Adjusts the knee aperture level.
DTL KNEE Adjusts the knee detail component.
LEVEL DEPEND Removes dark details.
DARK DTL Set the level of dark detail enhancement.
DTL SW Enables or disables the UHD detail effect.
LEVEL DPND SW Removes dark details.
DRK DTL SW Enhances dark details.
C 0 1 : A K - U C 4 0 0 0
U H D D T L
H DTL
M.DTL LEVEL
0 20
CRISP CLIP+
0
KNEE DTL
APETURE KNEE
0
C 0 1 : A K - U C 4 0 0 0
U H D D T L
DTL LEVEL
SW DPND SW
ON ON
Cannot be set simultaneously with [DARK DTL].
Cannot be set simultaneously with [LEVEL DEPEND].
1 / 2
V DTL PEAK
LEVEL FRQ
32 4
CLIP-
0 0
LEVEL DARK
DEPEND DTL
0 8 0
2 / 2
DRK DTL
SW
OFF
Setting details
- 86 -
ROP menu