Sony HKCA-700 Operation Manual page 36

Location and Function of Parts
8 CURSOR memory 1, 2, and 3 buttons
Used to store the size and position of the box cursor
displayed on the viewfinder screen. Three different
box cursor settings may be saved using buttons 1, 2,
and 3. Pressing one of these buttons will cause a
cursor of the stored size to be displayed in the stored
position.
Note
When one of the CURSOR buttons is lit up, the H-POSI, V-
POSI, WIDTH, and HEIGHT buttons (6 through 9) will
be disabled.
9 CURSOR ON button
When this button is pressed, the button will light up
and the box cursor will be displayed on the viewfinder
screen. When the button is pressed again, the light
will go out and the box cursor will disappear.
!º Video signal selection switch
Selects the video signal (Y, R, G, or B) for output to
the viewfinder.
!¡ CALL button
Press to call the operator of the HDCU-700A, the
MSU-700 Master Setup Unit, or the RCP-700 series
Remote Control Panel. When this button is pressed,
the HDCU-700A's red tally lamp will light up if
previously off, and turn off if previously lit. The
CALL button on the MSU-700 or RCP-700 series will
light up, and their buzzer will sound. Also, when the
CALL button on the RCP-700 series or MSU-700 is
pressed, this button will light up.
10(E)