Philips Solarium HB404 Manual page 11

troubleshooting
If problems should arise with this appliance and you are unable to solve them with the information
below, please contact the nearest Philips service centre or the Philips Customer Care Centre in
your country.
Problem
The appliance does not
start
Poor tanning results
Solution
Make sure the plug has been properly inserted into the wall socket.
There may be a power failure. Check if the power supply works by
connecting another appliance.
The timer may not have been set. Set the timer to the appropriate
tanning time.
The lamp may still be too warm to restart. Let the lamp cool down for
3 minutes before you switch it on again.
Perhaps you use an extension cord that is too long or does not have
the correct current rating. Consult your dealer. Our general advice is
not to use an extension cord.
You may have followed a tanning course that is not appropriate for your
skin type. Check the table in section 'Tanning sessions: how often and
how long?'.
Perhaps the distance between the lamp and your body is larger than
prescribed.
When you have used the lamp for a long time, its tanning capacity
decreases. This effect only becomes noticeable after several years. To
solve this problem, select a slightly longer tanning time or have the lamp
replaced.
EngliSH
11