Program Selection; Automatic Programs; Time Programs; Options - Bosch 100 Series Operating, Care And Installation Instructions Manual

Program selection

For optimum drying results your dryer
offers several program groups and
additional options.
Select the required drying program
from the program table according to
the examples (see page 15).

Automatic programs

There are automatic programs for
different types of textiles.
(Regular/Cotton, Permanent Press).
Regular/Cotton
Permanent Press
The program sequence of automatic
programs is controlled via sensors. The
duration of the program depends on
the measured degree of moisture in the
laundry and on the selected degree of
dryness (e.g. Damp dry or Extra dry).

Time programs

Time programs run for a specific time
(20, 40, 60 minutes).
In the "Air fluff" stage the dryer runs on
ambient air without a heat supply for 20
minutes.
14
All manuals and user guides at all-guides.com
i Dry woolen or wool-rich textiles
with dryer rack only!

Options

Delicates
Press the "Delicates" button for
temperature sensitive textiles. Observe
the care information or symbols on the
textiles. The temperature of the drying
process is reduced, the drying time is
extended.
Signal
Your dryer outputs different signals, if
the "Signal" button is pressed.
Signal Type
Start Short tone
End Sequence of short
tones
Mal operation Sequence of long tones
Warning of Sequence of long tones
malfunction
i The signal
Warning of malfunction" is active
in any case.
Indicator of program
sequence
The dryer uses an electronic scanning
system for all programs except the time
programs . A moisture sensor
continuously checks the moisture in the
laundry. Drying ends automatically as
soon as the selected degree of dryness
has been reached.
The drum continues to rotate at
specific intervals for one hour to
prevent creasing.
The current degree of drying and the
level reached during the program
sequence is indicated via indicator
lights (Drying, Damp dry, Regular dry,
Wrinkle block).
i If the indicator light Wrinkle block"
illuminates when the program
selector is in Off-Position - turn off
the circuit breaker and call for
customer service!