Cleaning And Maintenance; Descaling Process - Bosch EasyComfort 6 Series Operating Instructions Manual

Cleaning & Maintenance
Calc'nClean Calc'nClean
Easy Easy

1. Descaling process

This appliance is equipped with an automatic clean
warning indicator, which indicates that scale particles
must be removed from inside the steam chamber.
When activated, three beeps will be heard and the
"Calc'nClean" indicator light (1) will lash, indicating
that the process should be performed.
You may continue ironing for a time. Once this time
has passed, you will only be able to dry iron (without
steam).
To start steam ironing again, follow this descaling
process:
1 Fill the tank (7) with water.
2 Plug in the mains cable (5) and press the button (2) to
switch the appliance on.
3 Press the descaling button (1) for 2 seconds. Its
indicator light will remain permanently lit.
4 Wait until the indicator light (2) stops lashing and
remains lit permanently. Two beeps will be heard.
5 Place the iron on the "Calc'nClean" container (14).
Make sure that the surface on which the container is
placed is stable.
Warnings:
• Do not remove the iron from the container until the
process has inished.
Boiling water and steam will be released through
the soleplate, removing limescale and/or deposits
that may be inside.
• The container must only be used to perform the
descaling process. It must not be used as a stand
for the iron while ironing.
6 Press the steam release button (13) for 2 seconds.
The descaling process will start automatically. During
this process, short beeps will be heard.
7 After approximately 3 minutes, the iron will stop
releasing steam. A long beep will be heard, indicating
that descaling process has inished. The appliance
will switch off automatically.
* Model dependent
3x
2"
2x
19
B OS CH