Table of Contents
Advertisement
Hot key3 (Selecting the input)
Open the Input control and select HDMI1 (2.0), HDMI2 (2.0), DP1, DP2 or Auto Source.
When you are done, press the joystick to exit current page and store.
Main Menu
1.
Press the MENU key to open the OSD.
2.
Toggle the joystick
toggle to the right to navigate to the element you wish to adjust and press the joystick
to enter it.
3.
Toggle the joystick
4.
Information Hot Key
5.
Modes Hot Key
6.
Exit Hot Key
X
Picture
• Brightness: Adjust the brightness from 0 to 100.
------------------------------------------------------------------------------------------------------
Note: Adjusts the balance between light and dark shades.
• Contrast: Adjust the contrast from 0 to 100.
------------------------------------------------------------------------------------------------------
Note: Sets the degree of difference between light and dark areas.
• Black Boost: Adjust the Black Boost from 0 to 10. Enhances shadows by increasing the
brightness without changing lighter shades.
------------------------------------------------------------------------------------------------------
Note: If the image is very bright or has few shadow areas, adjusting this setting may
not result in any noticeable changes to the image.
• Blue Light: Filters out blue light to protect your eyes by adjusting how much blue light is
shown -- Off, 80%, 70%, 60%, or 50%.
------------------------------------------------------------------------------------------------------
Note: Higher values allow more blue light through. For the best protection select a
lower value.
When "Blue Light" is on, Brightness & Contrast will show each level of "Blue
Input
Auto Source
Move
to the up
or down
to the left or right to adjust the sliding scales.
Show Monitor Information and Reset control function.
:
To change Modes Hot Key menu.
:
to exit current page and store.
Mode - Standard
Picture
Brightness
Color
Contrast
Black Boost
Audio
Gaming
Blue Light
ACM
OSD
HDR
System
Light Sensor
Super Sharpness
Move
Enter
Input
HDMI1(2.0)
On
Enter
Exit
to select Picture from the OSD.Then
80
50
5
Off
Off
Off
Off
Off
13
XV273K User Guide English
X
Advertisement
Table of Contents
