Setting The Wordclock - Yamaha 01V Owner's Manual

Setting the Wordclock

The 01V can generate its own internal wordclock at 44.1 kHz (the industry-standard
sampling rate for music CDs) or synchronize to an external wordclock of between
44.1 kHz –10% and 48 kHz +6%, which can be sourced from the Digital Stereo In or a
digital Option I/O card.
Note: If the 01V is the only digital audio device in your system, you do not need to change
the wordclock source. It can be left at internal 44.1 kHz.
1. Use the [SETUP] button to locate SETUP page 1, as shown below.
Note: When the wordclock source is changed, audible glitches or clicks may be produced,
so it's a good idea to turn down the volume on all monitor amps and headphones first.
2. Use the cursor buttons to select the SOURCE switches, and the [ENTER]
button to set them.
AUTO NAVIGATE —This function checks all possible wordclock sources and then dis-
plays a dialog box recommending a suitable source. Note that in some situations this
function may not be able to recommend a suitable source. The following dialog box
appears when this function is run. Select OK, and press the [ENTER] button to start
digital input scanning.
To select the wordclock source manually, use the following switches.
This switch selects the internal 44.1 kHz wordclock. A highlighted switch like
the one shown here indicates that the 01V is synchronized to the wordclock
source and ready for use.
This switch selects the Digital Stereo In as the wordclock source. A switch like
the one shown here with a single diagonal line indicates that a wordclock sig-
nal is present at this input but the 01V is not synchronized to it.
This switch selects the Option I/O card as the wordclock source. A switch like
the one shown here with two diagonal lines indicates that no wordclock signal
is present at this input.

Setting the Wordclock

01V—Owner's Manual
209