Connecting Speakers - Yamaha MusicCast RX-V483 Owner's Manual

2

Connecting speakers

Connect the speakers placed in your room to the unit. The following diagrams provide connections for a 5.1-channel system as an example. For other systems, connect speakers
while referring to the connection diagram for the 5.1-channel system.
Notice
▪ Remove the unit's power cable from an AC wall outlet and turn off the subwoofer before connecting the speakers.
▪ The speaker has the polarity (+/-). Connect the speaker cable correctly between the positive (+) terminal of the unit and the speaker, and also between the negative (-) terminal of them.
Cables required for connection (commercially available)
Speaker cables (x the number of speakers)
+ +
– –
(TV)
(TV)
Audio pin cable
9
Subwoofer
Use a subwoofer with built-in amplifier.
2 1
Front (R) Front (L)
1 2
3
10 mm
(3/8")
3
Center
Audio pin cable (x1: for connecting a subwoofer)
Precaution for connecting of the speaker cables
4
▪ Prepare speaker cables in a place away from the unit, to avoid
▪ Improper connecting of the speaker cables may cause short circuit and
▪ If "Check SP Wires" appear on the front display when the unit is turned
5 4
Surround (R) Surround (L)
19
En
accidentally dropping wire strands into the unit's interior which could
result in a short circuit or malfunction of the unit.
also damage the unit or the speakers.
– Twist the bare wires of the speaker cables
firmly together.
– Do not let the bare wires of the speaker
cable touch one another.
– Do not let the bare wires of the speaker
cable come into contact with the unit's
metal parts (rear panel and screws).
on, turn off the unit, and then check the speaker cables short circuit.