How To Install - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Procedure 15-1 How to Install Additional Base Radio to MTS 2
1
2
3
4
5
6
7
8
6802800U74-N September 2009
Remove the Blind Plate where the additional Base Radio is to be assembled.
Label all new Rx cables with labels included in the expansion kit.
Attach the Rx cables to the filters. Connect them according to the scheme below:
Part no
#
5
3066543B01 Rx cable
6 3066543B01 Rx cable
7 3066543B01 Rx cable
Index numbers in table above refer to cable connections shown in
At this stage only connect the cables to the filters.
Attach the Tx-cable to the Tx input of the filter in position 2.
At this stage only connect the cable to the filter.
Attach the Ethernet cable 3066544B02 to the BR2 connector on the Site Controller. This is
illustrated in Figure 15-4
At this stage only connect the cable to the Site Controller. Follow the color scheme
displayed on the Site Controller front panel.
Insert the additional Base Radio by aligning the side rails with the appropriate rail guides inside
the Base Radio chassis.
Gently push the additional module completely into the Base Radio chassis assembly using
the module handle.
Be careful not to damage any of the cables previously connected when
pushing the Base Radio into position.
Secure the additional module using two TORX screws. Tighten the screws to a torque of 2.7 Nm.
Cable type
as connection #2.
La- From
bel
Rx1 Filter pos 1 /
BR2
Rx2 Filter pos 2 /
BR2
Rx3 Filter pos 3 /
BR2

How to Install

To
BR2 / Rx1
BR2 / Rx2
BR2 / Rx3
Figure 15-3.
15-5