Self-Diagnosis - Panasonic DMR E50 Operating Instructions Manual

The self-diagnosis displays appear if a problem occurs with the unit.
The service numbers in the table appear when a problem occurs.
≥The service numbers are a "U" followed by two digits.
Service
Unit status
number
NO READ The disc is dirty or badly
scratched.
It cannot be read for the
disk which doesn't cope
with it.
The DVD-RAM/PD lens
cleaner has finished
cleaning.
UNSUPPORT You have inserted a disc
the unit cannot play or
record on.
U14 The unit is hot.
U99 The unit fails to operate
properly.
REMOTE The remote control code is
DVD wrong.
RECOVER A power failure occurred or
the AC mains plug was
disconnected while the
power was ON.

Self-diagnosis

Service number
Solutions
≥Follow the instructions in "Maintenance and Handling" to clean the disc if it is dirty.
(page 69)
≥The disc cannot be played if it is scratched and this display doesn't disappear.
≥It cannot be read for the disk which doesn't cope with it. Exchange a disk.
≥Take the cleaner out of the unit.
≥Insert a disc the unit can play or record on. (page 10)
≥The unit switches to standby automatically for safety reasons and you cannot operate it.
Wait for about 30 minutes for the service number to disappear.
≥Select a position with good ventilation when installing the unit.
≥Do not block the cooling fan on the rear of the unit.
≥Press [Í] to switch the unit to standby. Now press [Í] again to turn the unit on.
≥Change to the correct code. (page 63)
≥The unit is carrying out its recovery process. Wait until the message disappears.
72