Connectors And Status Indicators (Its4834B And Its4834C); Intellivue Smart-Hopping Core Ap Connectors - Philips ITS4843B Installation Manual

Connectors and Status Indicators (ITS4834B and ITS4834C)

Figure 1-4 shows the controls and connectors on the 1.4 GHz IntelliVue Smart-
hopping Core AP and Remote Antenna.
IntelliVue Smart-hopping
Figure 1-4: 1.4 GHz IntelliVue Smart-hopping Core AP and Remote Antenna Controls

IntelliVue Smart-hopping Core AP Connectors

Note the following connectors on the IntelliVue Smart-hopping Core AP:
• Ethernet Interface - The AP provides a 100 Base-T Ethernet interface with an
RJ-45 connector to connect the Core AP to the IntelliVue Smart-hopping Sync
Unit.
The AP Ethernet interface provides data communications to and from the
IntelliVue Information Center over the IntelliVue Smart-hopping LAN
infrastructure. It also presents the 48Vdc power and synchronization signals
required by the Core AP. The synchronization signal is superimposed on the
power supply voltage. Attach the provided ferrite block to the CAT 5 cabling
(from the Sync Unit) no more than 20 inches (50 cm) from the RJ-45 connector
as shown in Figure 2-2 to reduce electromagnetic (radiation) interference.
Table 1-2 lists the pin signals for the AP Ethernet interface.
IntelliVue Smart-hopping 1.4 GHz Access Point Installation Guide
Activity LED
Link LED
Power/Sync, Radio,
Ethernet Interface to
and Network
Status LEDs
Connection LED
(Green)
UTP Cable Connector
to IntelliVue Smart-hopping
Table 1-2: AP Ethernet Interface Pin Signals
Pin
1 Transmit Pair TX + Conductor
2 Transmit Pair TX - Conductor
3 Receive Pair RX + Conductor
4 + 48Vdc Power and Synchronization
5 + 48Vdc Power and Synchronization
Connectors and Status Indicators (ITS4834B and ITS4834C)
IntelliVue Smart-
hopping Core Access
Serial Port
IntelliVue Smart-hopping
Remote Antenna
and Connectors
Signal Description
Coaxial Cable Connectors
to Remote Antennas (1 & 2)
UTP Cable Connectors
to Remote Antennas (1 & 2)
with RA Status LEDs
Power LED
(Yellow)
Coaxial Cable Connector
to IntelliVue Smart-hopping
Core Access Point
1-9