Panasonic ET-DFD95 Installation Instructions Manual page 12

Assembly process
Upper frame
[4] Fix the upper frame in place using the washer (B), washer (C), fixing nut (M10), hex nut (M10) and snap pin .
5. Attach the upper frame and upper projector to the left and right frames and gas springs.
Insert the washer into the connection hole
on the other side in the same manner.
12
(continued)
Upper projector
Upper projector
Upper frame
Washer
Connection hole
[3] Place the upper frame over the adjustment bolts as
shown on the left.
Hex nut (M10)
Fixing nut (M10)
Rounded side
Indented side of washer
Washer(B)
Note : Use washer (C) for
washer (B).
Snap pin
After inserting the snap pin in the bolt hole, turn it
to the side as shown below.
[1] Turn the upper frame and upper projector over so
that the projector is right side up. Insert the washers
in the upper frame connection holes as shown at left.
Snap pin
. Washer (C) is thinner than