Alarm Operation; Sleep Timer Operation - JVC RA-E211B Instruction Manual

ALARM OPERATION

NOTE: Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 or Alarm 2
• In standby mode, press and hold AL1 or AL2 for 2 seconds. The hour and
minute digits will flash.
• Set the alarm time by repeatedly pressing hr and min respectively.
NOTE: Press and hold hr and min for fast forward.
• Press AL1 or AL2 again to select the alarm sound (OFF > BUZZER > RADIO
in cycle).
Checking alarm time
Press and hold AL1 or AL2 for 2 seconds, the alarm time will flash on the
display.
Turn off the alarm
Press power to turn off the alarm. The alarm will come on again at the set time
on the following days.
Snooze function
This function can be used to stop the alarm temporarily for about 9 minutes
once the alarm is activated. When the snooze button is pressed, the buzzer or
radio alarm sounds will stop and sound again after about 9 minutes.
To cancel the alarm
Press repeatedly AL1 or AL2 until the alarm indicator light goes out on the
display.

SLEEP TIMER OPERATION

The sleep function is designed to automatically turn off the Radio.
Setting sleep timer
• Press sleep, "90" will illuminate on the display.
• Press repeatedly sleep to select the desired sleep time from 90, 80, 70, 60,
50, 40, 30, 20 or 10 minutes.
• The radio will be turned off after the selected time has elapsed.
NOTE: To check remaining sleep time, press sleep. To cancel sleep timer, press sleep until
"OFF" is selected. To turn off the radio before the sleep time has elapsed, press power.
PROJECTOR
Switch on the projection clock by pressing the Projection On/Flip/Off. Press
and hold this button for 2 seconds to flip the projection view upside down.
To switch off the projection clock press this button again.
EN