Yamaha Electone STAGEA ELC-02 Owner's Manual page 42

Settings Selected from the Voice Condition Display
5 FEET
Determines the octave setting of the Voice, letting you
use the Voice over a wide register. There are three
settings: 4', 8' and 16' (4' is highest and 16' is lowest). A 2'
setting is added to the Pedal Voice sections. PRESET is
the original (factory) setting.
6 REVERB
Determines the amount of reverb applied to each Voice
section. When the panel REVERB control is set to the
minimum, the setting here will have no effect.
See page 44 for details.
7 BRILLIANCE
Determines the tonal quality of the Voice, brighter or
mellower. Range is from -3 to +3. Higher settings makes
the Voice tone brighter.
8 VOLUME
Fine adjustment of the Voice volume. See page 26 for
more information.
9 PRIORITY (only for the Lead Voice 2)
Determines the mode of Lead Voice 2, Last or Top.
• LAST: Only the last played key is sounded when two or
more keys are played simultaneously.
• TOP: Only the highest note is sounded when two or
more keys are played simultaneously. When the Solo
mode is on, Lead Voice 2 sounds according to Last
mode, regardless of the setting made here.
Reference page
• Solo function (page 27)
) POLY (only for Pedal Voices)
Allows you to switch the pedal polyphonic mode on or
off. Setting POLY to on switches the normally
monophonic pedal Voices to polyphonic play. This makes
it possible to play the Pedalboard in various expressive
ways, such as playing legato or playing intervals and
chords.
Keep in mind that you cannot exceed the total maximum
polyphony: 14 notes for all sections, Upper, Lower and
Pedal.
42 ELC-02/ELCU-M02 Owner's Manual
Voice Condition [Page 2]
1 - 1
1
1 - 2 1 - 3 1 - 4 2
The items included in this page differ between the Lead
Voice sections and the other sections. SLIDE (3) only
applies to Lead Voice 1 and 2.
1 VIBRATO
The Vibrato function wavers the level of the Voices,
making them sound warmer and more animated. This
effect is applied independently to each Voice section. For
some Voices, vibrato may not be effective at all or the
effect may not sound as expected.
1 -1 PRESET/USER
Selecting PRESET calls up the original (factory)
vibrato settings for the Voice.
When PRESET is selected, DELAY, DEPTH and
SPEED parameters cannot be edited.
Selecting USER lets you adjust the vibrato settings
for yourself.
Vibrato Control
Delay
1 -2 DELAY
Determines the amount of time that elapses between
the playing of a key and the start of the vibrato
effect. Higher settings increase the delay of the
vibrato onset.
Range: 0 – 14
1 -3 DEPTH
Determines the intensity of the vibrato effect.
Higher settings result in a more pronounced vibrato.
The minimum setting cancels the vibrato effect.
Range: 0 – 14
3 4
3 - 1 3 - 2 4 - 1 4 - 2
Speed