EN | 2 HSG9483 Series | Instruction Manual | Important Safeguards Important Safeguards 1. Read, Follow, and Retain Instructions - All safety 10. Power Sources - Operate the unit only from the type and operating instructions should be read and of power source indicated on the label.
Page 3
EN | 3 HSG9483 Series | Instruction Manual | Safety Precautions Safety Precautions For Indoor Product 1. Water and Moisture - Do not use this unit near water - for example, in a wet basement, in an unprotected outdoor installation, or in any area classified as a wet location.
Page 4
EN | 4 HSG9483 Series | Instruction Manual | Safety Precautions Sécurité Precauciones de Seguridad PRECAUCIÓN: PARA DISMINUIR EL RIESGO DE DESCARGA ATTENTION : POUR ÉVITER TOUT RISQUE D'ÉLECTROCUTION, ELÉCTRICA, NO RETIRE LA CUBIERTA (NI LA PARTE N'ESSAYEZ PAS DE RETIRER LE CAPOT (OU LE PANNEAU POSTERIOR).
Page 5
EN | 5 HSG9483 Series | Instruction Manual | Safety Precautions Sicurezza Zasady Bezpieczeństwa ATTENZIONE: PER RIDURRE IL RISCHIO DI SCOSSE PRZESTROGA: ABY ZMNIEJSZYĆ RYZYKO PORAŻENIA ELETTRICHE NON RIMUOVERE LA COPERTURA (O IL ELEKTRYCZNEGO, NIE NALEŻY ZDEJMOWAĆ POKRYWY PANNELLO POSTERIORE). L'UNITÀ NON CONTIENE GÓRNEJ (ani tylnej).
If an item appears to have been damaged in shipment, UNPACKING replace it properly in its carton and notify the shipper. This electronic equipment should be unpacked and If any items are missing, notify your Bosch Security handled carefully. Systems, Inc. Sales Representative or Customer Service •...
EN | 8 HSG9483 Series | Instruction Manual | Installation Input Power Cord - European INSTALLATION Cable Type: H05RN-F 3 G 0.75 and CAUTION: These units must be properly H05RN-F 3 G 1.00 and securely mounted to a supporting Cable Size:...
EN | 9 HSG9483 Series | Instruction Manual | Installation For installations of zoom lens cameras: Camera/Lens Installation Attach the lens to the camera. Remove the two screws holding the camera tray to the housing. Remove tray from the Use the various 1/4-20 screws and housing.
Page 10
EN | 10 HSG9483 Series | Instruction Manual | Installation Feed-through Wiring Install one of the large 1/2in. NPT fittings into one of the holes in the rear Use feed-through mounts to feed cabling cap. If using the feed-through option, through the foot of the housing.
EN | 11 HSG9483 Series | Instruction Manual | Installation Pull any excess wire out of the housing Video Coax Connection and tighten the fitting to 8.5 . N . m to See SECTION 5 for HSG9483/22, HSG9483/52, and 9.0 N . m (75in . lb to 80in . lb). This torque HSG9483/53 Models.
EN | 12 HSG9483 Series | Instruction Manual | Installation Optional tamper-resistant screws are provided Lens Wiring with the housing. If desired, secure the latch WARNING: For lens wiring, use only the using these two screws and the provided cables specified under INSTALLATION, tamper-resistant wrench.
EN | 13 HSG9483 Series | Instruction Manual | HSG9483/22,/52,/53 Connect the power input cable to the screw HSG9483/22, HSG9483/52, terminals on the provided mating connector and HSG9483/53 MODELS (see FIGURE 9 and Wiring Diagram for pin Camera/Lens Wiring connections).
EN | 14 HSG9483 Series | Instruction Manual | Operation OPERATION SERVICE PARTS These housings require no operational adjustments Description Part No. other than camera/lens adjustments. Spacer, 4mm, ABS 77018-00 Spacer, 9mm, ABS 77019-00 MAINTENANCE Screw, Tamper-resistant 77029-00 No special maintenance is required other than Wrench, Tamper-resistant 87017-00 occasional cleaning of the window.
EN | 15 HSG9483 Series | Instruction Manual | Exploded View EXPLODED VIEW Part # Description Part # Description 36001-00 Front Assembly for all models 35722-00 115VAC Heater (HSG9483/61) 35741-00 Sunshield Kit for all models 35723-00 220VAC Heater Kit (HSG9483/50/51/52/53)