7
Cable Connections
7.1
Cable Connections
Connect the CANBUS EXTENSION from CAN1 to the CANBUS lead on the main harness
or to the FEMALE CONNECTOR on the armrest (if equipped).
Connect the MALE CONNECTOR to CAN2 of the RCE harness.
If switches are present: Connect the power harness to the ignition, disconnect then to the 2
PIN CONNECTOR.
•
P3 interconnects with the 16 PIN ARMREST CONNECTOR. Connect the power
harness to battery or ignition disconnect.
•
P5 is for the AUXILIARY CABLE with bare leads. (See OSD for pinouts.)
Bosch Rexroth Canada ı May 2019 ı Revision 5.0
11/20