Table of Contents
Advertisement
68/81
Bosch Rexroth AG
Software
9.2
Touch Screen Software
The following applies to all settings:
The UPS service is stopped. All changes will only be effective, when
the PC is restarted (switch off and switch on the supply voltage
again).
About
The Shutdown Count value indicated in the About tab indicates, how often the
UPS has already shut down the system. A battery change is recommended
after more than 3000 forced shutdowns by the UPS, but not later than the rec‐
ommended maintenance interval, see
Fig.9-9:
About tab
For certain VDP-type displays a touch screen is integrated, that allows the op‐
eration via the touch-sensitive surface of the display.
To ensure the communication of the touch screen controller with the PC, the
serial interface XCOM2 inside the device is used. Therefore, the XCOM2 in‐
terface must not be used on these devices.
The required driver software is to be installed by means of the installation soft‐
ware "BRCVInstall", which is archived on the desktop.
After the installation settings and changes in the application Pointer Devices in
the Windows control panel are possible. The setup program can also be
reached via Start ▶ Programs ▶ UPDD ▶ Settings
DOK-SUPPL*-VPB*40.1***-PR02-EN-P
Rexroth IndraControl VPB 40.1 Control Cabinet PC
"Battery" on page
23.
Advertisement
Table of Contents
