Table of Contents
Advertisement
20
4-
Information about fans, power supply and lithium battery
4Troubleshooting with BIOS
Depending on your system, you can obtain this information as follows:
R630/R640
•
Reboot the computer
•
During the BIOS routine, press the F2 button.
•
Enter the password, according to the password list of your modality (to be found in the
knowledge database).
•
Go to the "Advanced" menu, select "Hardware Monitoring", and press Enter. Then
select "Realtime sensors" and press Enter.
Fans
Check to make sure that all fans listed are running. An "RPM" value must be shown. Visu-
ally check any fan for which this information is not shown. The RPM value depends on the
temperature and can vary.
Power supply
Check the value for VCC 5V and VCC 12V for R640, or the WB 5V, WB -12V and WB 12V.
The permissible range is ± 5%. If the system is unstable and this range is exceeded, the
power supply is probably defective.
Lithium battery
Check the value for the battery. If the value is less than 3 V, replace the battery.
M440 / M450
•
Reboot the computer
•
During the BIOS routine, press the F2 button.
•
Enter the password, according to the password list of your modality (to be found in the
knowledge database).
R630/R640; M440/M450
The system will ask for the BIOS password.
The "BIOS Setup Utility" window appears.
An information screen will appear.
NOTE
To exit the BIOS, go to the EXIT menu and select "Quit with-
out saving".
The system will ask for the BIOS password.
The "BIOS Setup Utility" window appears.
TD00-400.840.10.03.02
02.08
Troubleshooting with BIOS
Page 20 of 32
CS SD SP/CO
0
0
0
Siemens
Medical Solutions
Advertisement
Table of Contents
