Dismounting; Dismounting Steps - Bosch Rexroth IndraControl XFE01.1-SY-01 Operating Instructions Manual

22/41
Mounting, dismounting and electric installation

10.4 Dismounting

WARNING
Disconnect the complete station and the components before dismounting the
components! Connect the voltage only again after dismounting.
To dismount, use a common tool such a slotted screwdriver with a
2.5 mm blade.

10.4.1 Dismounting steps

NOTICE
Before mounting or dismounting components, disconnect the control - including
its components - from voltage.
Removing extension modules from top-hat rail
1. Remove the left end clamp.
2. Use a suitable tool (e.g. slotted screwdriver) and put it first into the upper
and then into the lower disengaging mechanism (base latch) of the control
and disengage the control (see (A) in the following figure). The base latch-
es are locked in the open position.
3. Remove the extension module vertically to the mounting rail (see (B) in the
following figure). The base latches engage again in idle position.
Bosch Rexroth AG R911376654_Edition 04
IndraControl XFE01.1-SY-01 Safety Ex-
Do not dismount the control, modules or plugs
under voltage. The system might start acciden-
tally!
Destruction of components due to dismounting
under voltage!
tension Module