About Base Station Installation; Connecting To Tv Signal - Sony LocationFree LF-X11 Operating Instructions Manual

About Base Station
Installation
• The SSID, WEP key, and initial password are
on the label affixed to the side of the Base
Station. This information is needed when you
are configuring Base Station settings from a
computer, not from the Monitor, and when you
are establishing a wireless connection from a
LocationFree device to the Base Station while
in Setup mode. When using LFA-PC2, the Base
Station should be installed so that you can
easily see its side.
• The Base Station should be installed at least 10
cm from the wall.
Connecting to TV
Signal
The procedure for connecting to a TV antenna
differs depending on the type of antenna jack.
Some antenna jacks require a separate converter
or splitter (not supplied). For more information,
contact your Sony dealer.
Antenna cable (not supplied)
to antenna
Connecting to a set-top box
There are two different procedures for connecting
a set-top box (STB), depending on whether the
set-top box connects to the antenna cable (not
Rear of Base Station
supplied) or to the video input terminal on the
Base Station.
Connecting to the antenna cable
STB
Cable outlet
Antenna cable
(not supplied)
Antenna cable
(not supplied)
Rear of Base Station
Connecting to the video input
terminal
See "Connecting Other Devices". (1 page 16)
Signal flow
15