Fitting And Removing Flange; Fitting Flange; Removing Flange - Bosch WBE 4510 Original Instructions Manual

en 42 | WBE 4510 | Fitting and removing fl ange
5.

Fitting and removing flange

Fitting of the flange is necessary in the following situations:
+
Commissioning
+
When changing the type of flange (universal - 3/4/5
hole)
+
When changing the type of wheel (passenger car -
motorcycle)
!
Balancing accuracy will be impaired if the flange has
not been properly fitted to the shaft.Before fitting
the flange, clean and degrease (remove corrosion
protection) the cone of the shaft and the flange
opening.
5.1

Fitting flange

i
Clean and degrease the cone of the shaft and the
flange opening.
1. Press the right pedal.
« This blocks the shaft.
2. Slide the flange onto the shaft.
3. Tighten the hexagon socket head bolt.
"
Flange fitted.
|
1 695 655 163 2010-07-17
5.2

Removing flange

i
The WBE 4510 must be switched on.
1. Press the right pedal.
« This blocks the shaft.
2. Slacken off the hexagon socket head bolt.
3. Unfasten the flange by tapping with a rubber-headed
hammer on the cone end.
4. Pull the flange off the cone.
"
Flange detached.
Robert Bosch GmbH