Panasonic YD-500GP5 Operating Instructions Manual page 27

（2）Ethernet connection
■ This product is equipped with a standard Ethernet communication interface, connected to a local area network
through a network cable, and communicates with the PC running the company's intelligent welding management
system iWeld software to realize the record management and parameter setting of welding data.
Connection
Internet connection
 Please ensure that the use occasion
has network connection conditions.
 In order to ensure the stability of
network
ensure
connected to this product is far
away from interference sources such
as power and electricity.
Network parameter configuration

The
welding machine is 172.16.XX.XX, and
the subnet mask is 255.255.0.0.

If
communication between the welding
machine
Ethernet, you need to set the IP
address of the PC to: 172.16.70.250,
and the subnet mask to: 255.255.0.0,
which can be used without changing
the
machine. Realize the connection with
iWeld software.
 If the welding machine is connected
to the local area network, you need
to change the IP address of the
welding machine and the IP address
of the data server, use the PC
serial cable to connect the serial
configuration
product,
configuration software IOT_CONFIG of
the company's welding machine on the
PC. Parameters are configured, and
the configuration method is detailed
in chapter 4.7.
23
communication,
that the network
default IP address
you want to realize
and the PC through
IP address of the
interface
and run the
please
cable
of the
data
the
welding
of this
special