Hitachi AJ-S75TXP User Manual page 40

Maintenance and Repair (continued)
維護保養方法（續）
When icing is possibly underway
有可能結冰時
1 Turn off the tap, and disassemble
the water supply hose.
(Refer to page 14 for proper
dis-assembly)
關閉水龍頭，拆下供水管。
（拆卸方法
14）
Make the water supply hose
2
downward, but don't bend it.
將供水管朝下，但不能讓其彎曲。
• Lest the water remained in the
charging hose will fl ow out.
以免殘留在供水管中的水流出。
Select the "Tub Clean" process, and the operation
3
will stop after 30 minutes.
選擇『筒清洗』程序，運轉 30 分鐘後停止運作。
• All the water remained in the charging hose can be drained.
可將殘留在供水管中的水全部排出。
4 Put down the water drainage hose, place its tail in water
container such as basin.
放下排水管，將其尾部放入水盆等盛水容器中。
Only set the "Spinning" 1 minute, and operation.
5
只設定『脫水』1 分鐘，運轉。
6 Switch off the power.
關閉電源開關。
How to maintain the water supply opening
供水口的保養
The contamination accumulated at the water supply opening will worsen the supply effect.
供水口積有髒物會影響供水效果。
Turn off the tap, and disassemble the water supply hose.
1
(Refer to page 13 for proper disassembly)
關閉水龍頭，卸下供水管。
（拆卸方法
13）
2 Clean up the contamination accumulated at the fi ltering net of water supply opening.
清除供水口濾網處積留的污物。
• If it's hard to clean up the contamination, disassemble the fi ltering net for east cleanout.
若污物不易清除時，可將濾網拆下以便清洗。
Attention
• The fi ltering net of water supply opening shall be recovered to the original shape after cleanout, so as to avoid the
failure of water supply valve.
供水口濾網清洗後，請務必恢復原狀，以免引起供水閥的故障。
Tap shall be closed fi rst before remounting the charging hose. Select "Blanket" process, slowly open the tap
after pressing the start button. (it shall be treated the same in case of long-term idleness.)
斷水後或拆掉供水管又再次裝上時，應先關閉水龍頭，選擇『被毯』程序，在按下開始按鈕後再緩慢打開水龍頭。( 長時間
停止也同樣處理 )
• If there is residue air in the water supply hose and water drainage hose, the washing machine could be damaged by
compressed air, leading to leakage or injury accident.
供水管、水管中有殘留空氣，洗衣機有可能因壓縮空氣而受損，從而造成漏水或傷害事故。
40
When icing happens 如果已經結冰時
Turn off
1 Disassemble the water supply
1
hose, and put it into the warm
water as hot as 40
卸下供水管，將其放入 40 度左
右的溫水中。
Water
2 Pour the warm water as hot as
supply hose
40
在槽內倒入 40 度左右的溫水。
3 Connect the water supply hose
to the tap, and check the wash-
ing machine to make sure the
water supply and drain are in
normal case.
再將供水管接至水龍頭，檢查洗
37
衣機是否正常進行供水、排水動
37
作。
Warning 警告
o
C.
o
C into the basket.
water supply opening