Panasonic KX-tg2248CS Operating Instructions Manual page 57

✿✤✦✪✤✧Z✮_✩.❇m 5✪
Problem
The unit does not display the
caller's name and/or phone
number.
The handset display exits the
Caller List or phone book.
You cannot page the handset
or base unit.
You cannot have a
conversation using the
headset.
Answering System
Problem
The Answering System is on,
but incoming messages are
not recorded.
You cannot listen to recorded
messages.
" " is displayed and the
FULL
ANSWER ON indicator
flashes rapidly. No new
messages are recorded.
] ]
Troubleshooting
Cause & Remedy
• You need to subscribe to a Call Display
service.
• Other telephone equipment may be interfering
with your phone. Disconnect it and try again.
• Other electrical appliances connected to the
same outlet may be interfering with Call
Display.
• Telephone line noise may be affecting Call
Display.
• The caller requested not to send his/her Call
Display information (p. 28).
• If a Call Display box is connected between the
unit and the telephone wall jack, disconnect
the Call Display box or plug the unit directly
into the wall jack.
• Do not pause for over 60 seconds while
searching.
• The handset is too far from the base unit.
• The handset user is making an outside call,
viewing the Caller List/phone book or listening
to messages. Wait until the IN USE/CHARGE
indicator light goes out.
• The handset or base unit is in use. Try again
later.
• Make sure the optional headset is connected
properly (p. 54).
• If " SP-phone " is displayed on the handset,
press [ ] to switch to the headset.
Cause & Remedy
• The recording time is set to "Greeting only".
Select "1 minute", "2 minutes" or "3 minutes"
(p. 22).
• Memory is full. Erase unnecessary messages
(p. 48).
• Make sure the unit is not being used.
• Memory is full. Erase unnecessary messages
(p. 48).
_
57