Table of Contents
Advertisement
8
ASSEMBLING AND PREPARING
Adjusting the stand height
1
Place the monitor mounted on the stand base
in an upright position.
2
Remove the tape attached at the bottom rear
of the stand body, then pull out the locking
pin.
Stand Body
Tape
3
The height can be adjusted up to 110 mm.
CAUTION
y
Once the pin is removed, it is not necessary
to re-insert it to adjust the height.
WARNING
y
Do not put your finger be-
tween the screen and the
base (chassis) when adjust-
ing the screen's height.
Locking Pin
110.0mm
Using the Kensington locking
device
The connector for the Kensington lock is located
on the rear of the monitor.
For more information on installation and usage,
refer to the Kensington lock user manual or visit
the website at http://www.kensington.com.
Connect the monitor to the table with the Kensing-
ton lock cable.
NOTE
y
Using the Kensington lock is optional. The
accessories can be purchased at your local
electronics store.
Advertisement
Table of Contents
