Panasonic YW-50DNW Operating Instructions Manual page 11

■Remote control function description
Panel operation function description：
Name
Abnormal
temperature
indicator
Inching Button
Initial arc Button
Switch Button
●When the temperature of important parts in the welding machine is
too high, an abnormal temperature alarm will be issued, the output will
stop, and this indicator will flash. Do not continue welding until this
indicator light goes out
●It is used to feed the welding wire into the wire feeding tube before
welding. This function is only available when this button is pressed.
After pressing the button, the motor rotates and the corresponding
panel indicator lights up. When it is released, the motor stops and the
indicator light goes out.
●2-step and 4-step switching.
Press the arc closing/initial button, the corresponding indicator light is
always on, indicating that the current state is 2 steps.
Press again to switch the status to 4 steps. Press again to switch to no
initial arc closing.
The first time it is turned on, the default state is no initial arc closing.
●Initial, welding, and arc current/voltage adjustment.
The first time it is turned on, the default state is that the welding
indicator is on and the welding parameters displayed by the digital
tube.
Description
6