Reset To Factory Default; Indication (Normal And Abnormal) - Hitachi airCloud HC-IOTGW Installation & Maintenance Manual

6. Reset to Factory Default

Turn ON the power for airCloud Gateway on the condition that the pins of DS1 are set as "Reset
to Factory Default" mode (refer to 3.2.3 Switch Setting Procedures), the setting of airCloud
Gateway will restore reset to default factory setting. After entering the factory reset program, all
LEDs except the power supply flash until the factory reset is completed, and all LEDs are turned
OFF.
The factory default settings are as below:
IP Address
Subnet Mask
Default Gateway
Primary DNS Servers
Second DNS Servers
Web Server Username
Web Server Password
After restoring factory settings, user needs to set the DS1 Pin1~Pin4 to the normal startup mode
and power on again. Restoring factory settings will clear previously added certificates.
Since the connection information is also removed when resetting to factory default, it will check
connection again at next power on.

7. Indication (Normal and Abnormal)

The indication of LEDs are as follows.
Name Color
POWER
Green The power supply is normal.
(5V)
Please refer to "Table 7.2 Indications and Condition for ERROR LED and Error Code of airCloud
ERROR Red
Gateway".
H-LINK Green -
Connect with cloud
UPLINK Green
successfully.
4G LINK Green Indicates the signal strength of 4G.
Table 6.1 Factory Settings
Name
Proxy
Get the default user name and password from the Appendix of
this manual.
Table 7.1 Indication of LEDs
Lights/indicates when
Factory Default Setting
192.168.0.23
255.255.255.0
192.168.0.1
192.168.0.1
Blank
Blank
Goes OFF/clears when
No power supply.
-
Cannot connect with cloud.
27
Flash when
-
Flash once every 2 seconds: no data
delivery.
Flash twice every 2 seconds: in data
delivery.
Flash rapidly and continueously: in
searching.
-