Installation Of The Device - Electrolux ECH/AG2-1000 3BE EEC User Manual

outlets (grilles), due to the risk of accident or
damage to the device. Do not place behind
curtains, doors, wall or air vents. Observe
the minimum installation distances on floors,
surfaces, furniture, etc.
100 mm
min.
Figure. 5
1. Wall mounted installation option
(bracket and mounting template
included)
Use the brackets to mount the heater on
the wall according to the pictures below.
The distance from the device to the floor
and surrounding objects must be at least 10
cm (Figure 5):
To install the bracket on a wall, follow these
steps:
• Attach the mounting template to the wall
in the place where you plan to place
the vector.
• Mark and drill holes.
• Place the bracket on the wall and secure
it with the fasteners.
Fix the device to the bracket as follows
(Figure 6):
• Place the lower part of
the bracket using the special holes located
in the lower part of the convector.
• Slide the upper part of the convector onto
the bracket, fixing it with the latches on the
bracket.
100 mm
min.
100 mm
min.
100 mm
min.
the convector onto
b
a
Figure. 6
Figure. 7
2. Floor installation
Using the chassis (supplied separately), having
previously studied the mounting scheme
(Figure 7), install the device on the floor:
1. Carefully turn the convector upside down.
2. Take one of the chassis and attach to
the landing area on the right or left side
of the convector so that it fits snugly
against the convector body
3. Secure the chassis using the supplied
mount.
4. Repeat the same procedure for attaching
the second chassis.
9
ENGLISH