SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Hardware Description
Table 6-25
tributaries.
Table 6-25 Mapping between the output tributary switches and the loading tributaries
Output Tributary Switch
BATT.
LOAD1
LOAD2
LOAD3
LOAD4
DIP Switch
The EPS75-4815AF power system provides a DIP switch, the DIP switch is on the right
middle of the monitoring module control board, which can be seen after you remove the
monitoring module. The DIP switch has eight available electrical switches. ON indicates 1,
and OFF indicates 0.
Table 6-26 Settings of the DIP switch
Electrical
Switch
1-5
6-7
8
The DIP switches 1-5 are used to set the address of the environment monitoring module,
Table 6-27
Issue 24 (2018-07-30)
shows the mapping between the output tributary switches and the loading
Table 6-26
describes the settings of DIP switch.
Setting
Indication
Supported
Used to set the address of the environment
monitoring module.
Supported
Used to set the rate of the serial port
Not
-
supported
shows the settings of the DIP switches.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Load Tributary
BATT. (-) (two channels) and BATT.(+) (two channels)
LOAD1 (-) (two channels) and LOAD1(+) (two
channels)
LOAD2 (-) (two channels) and LOAD2(+) (two
channels)
LOAD3 (-), LOAD3(+)
LOAD4 (-), LOAD4(+)
6 Electromechanical Device
Factory
Default
1: OFF
2: OFF
3: OFF
4: OFF
5: OFF
6: ON
7: OFF
OFF
940