Table of Contents
Advertisement
C-47
Programming
STEP 1:
ASYD - System Data 1, Index 5, Bit 0. Access codes for CALL FORWARDING-BUSY LINE - CCIS
and CALL FORWARDING-DON'T ANSWER - CCIS are same or separate? 0/1: Same/Separate.
System Data 1, Index 69, Bit 2. Is there a short tone to alert person receiving the call that this is a
CALL FORWARDING-DON'T ANSWER - CCIS call? 0/1: No/Yes.
System Data 1, Index 139. Assign the No Answer time for station-to-station, DID, and TIE Line calls.
For 30 seconds, assign 00H (RAM data is 3FH).
System Data 1, Index 141. Assign the No Answer timer for incoming calls via the Attendant Console.
It will then be forwarded to the next station according to System Data 1, Index 145 timer. For 10
seconds, assign 00H (RAM data is 35H).
System Data 1, Index 145. Assign the time an incoming call via the Attendant Console will ring at the
CALL FORWARD-DON'T ANSWER - CCIS station before recalling to the Attendant Console. For
30 seconds, assign 00H (RAM data is 9FH).
System Data 2, Index 6, Bit 7. Enable CALL FORWARDING-DON'T ANSWER - CCIS via
Attendant Console Transfer.
STEP 2:
ANPD - Reserve a number level for feature access and cancel. Assign for Normal (N), Hooking (H),
and Busy (B). Assign NND in accordance with a predetermined numbering plan.
STEP 3:
ASPA - Assign an access code to CALL FORWARDING-DON'T ANSWER - CCIS entry, SID = 12,
and to CALL FORWARDING-DON'T ANSWER - CCIS cancel SID = 13. Assign Connection Status
Index (CI) for Normal (N) service.
STEP 4:
ASFC - Assign a Service Feature Class that allow SFI = 8 to the stations receiving CALL
FORWARDING-DON'T ANSWER - CCIS.
STEP 5:
AKYD - For D
programmable line/feature key. Assign Type:Function:CALL FORWARD-DON'T ANSWER [22].
STEP 6:
ADSL - Assign FDN key; Assign SN=1 (Originating; DT Connection) and FKY=22 (Call Forwarding
- Don't Answer).
This command is used for assigning a function to each soft key.
STEP 7:
ATNR - Allow tenant-to-tenant connection for Inter- and Intra-tenant connections. Assign Tenant
Restriction Index (TRI) = 1. For this feature to be set by the Attendant Console, assign Inter-and Intra-
Tenant connection via the Attendant Console, TRI = 3.
STEP 8:
ACFO - For tenant-wide CALL FORWARDING-DON'T ANSWER - CCIS, assign CF = 2 for a
destination (CFI) of either the Attendant Console or a station.
Page 846
Call Forwarding - Don't Answer - CCIS
term
sets, CALL FORWARDING-DON'T ANSWER - CCIS may be assigned to a
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
