Sony HDCU2500 Maintenance Manual page 136

6. Remove the two screws (B2.6 x 5) , and remove the SDP-17 board.
Heat trans sheets (1)
Spacer (A)
SDP-17
shield plate
7. Install the removed parts by reversing the steps of removal.
Note
When installing the SDP-17 board, arrange the optical cables as shown in the figure below.
Pass the optical cables
between chip parts.
SDP-17 board
Do not pass the
optical cables
over this part.
Tab
Pass the optical
cables under the tab.
HDCU2500
Spacer (A)
SDP-17 board
B2.6 x 5
Rear panel
UL tape
B3 x 5
Optical cables
4-18