Page 17
Contents 6 Replace the filter and wick 1 Important Understanding the healthy Safety air protect lock 2 You humidifier Replacing the Nano protect filter Product overview (fig. a ) Replacing the NanoCloud Controls Overview (fig. b ) rotary humidification wick Replacing the anti-bacteria 3 Get started cartridge (HU5931 only)
• If the power cord is • Do not let water or any damaged, you must have other liquid or flammable it replaced by Philips, a detergent enter the service center authorized appliance to avoid electric by Philips, or similarly shock and/or a fire hazard.
Page 19
• If the power socket used appliance. to power the appliance • Only use the original has poor connections, Philips filters specially the plug of the appliance intended for this becomes hot. Make appliance. Do not use any sure that you plug the other filters.
Page 20
• Always lift or move at least 2m away from the appliance by both electrical appliances that handles at the sides of the use airborne radio waves appliance. such as TVs, radios, and • Do not insert your fingers radio-controlled clocks. •...
Page 21
• Only fill the water tank with cold tap water. Do not use ground water or hot water. • Do not put any substance other than water in the water tank. Do not put fragrance in the water tank. • If you do not use the humidification function for a long time, clean the water tank and...
Congratulations on your purchase, and welcome to Philips! Air humidity light ring (HU5931 To fully benefit from the support that only) Philips offers, register your product at www.Philips.com/welcome. Child lock button The Philips humidifier brings fresh, Timer button humidified air to your house for the health of your family.
3 Get started Preparing for humidification Pull out the water tank (fig. h). Installing the Nano Pull out the water tray (fig. i). protect filter Remove all packaging material of the NanoCloud rotary The appliance comes with the Nano humidification wick (fig. j). protect filter fitted inside.
4 Use the Setting the humidity appliance level Touch the humidity button repeatedly to set the desired air humidity to 40%RH, 50%RH, Switching on and off 60%RH or " " (fig. u). Put the plug in the power socket. Note »...
Changing the fan speed Setting the child lock Auto ( ) Touch and hold the child lock button for 3 seconds to activate In auto mode, the appliance selects child lock (fig. z & {). the fan speed in accordance with the »...
5 Cleaning Note • When there is no water in the water tank, the wick wheel will stop rotating. In the auto mode, the Note appliance will operate under fan speed 1. In the manual fan speed • Always unplug the appliance before mode, the appliance will continue cleaning.
Cleaning the body of the Note appliance • Do not take the NanoCloud rotary humidification wick off the wheel during cleaning. Regularly clean the inside and outside • Do not scrub the NanoCloud rotary of the appliance to prevent dust from humidification wick or place it under collecting.
Pull the top part of the back panel Soak the NanoCloud rotary towards you to release it from the humidication wick in cleansing appliance (fig. c). agent (e.g diluted white vinegar, Citric acid solution) for two hours. To remove the pre-filter, press the two clips down and pull the filter Note towards you (fig.
6 Replace the Note filter and wick • Do not touch the pleated filter surface, or smell the filter as it has collected pollutants from the air. • Wash your hands after disposing of the used filters. Understanding the Remove all packaging material of healthy air protect lock the new Nano protect filter (fig.
Place the new NanoCloud rotary humidification wick in the wick wheel, and then fasten the locks on the wick wheel (fig. ). Place the wick wheel on the wick support (fig. k). Note • When placing the wick wheel on the wick support, make sure that the projections on the wick wheel falls into the corresponding grooves.
Troubleshooting This chapter summarizes the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, contact the Consumer Care Center in your country. Problem Possible solution • The filter replacement light has been flashing but you have not replaced the Nano protect filter, and the appliance The appliance...
Page 32
The first few times you use the appliance, it may produce a plastic smell. This is normal. However, if the appliance produces a burnt smell, contact your Philips dealer or an The appliance authorized Philips service centre. The filter may produce smell...
Philips Consumer Care Center in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local Philips dealer. Order parts or accessories If you have to replace a part or want to purchase an additional part, go to your Philips dealer or visit www.philips.com/...
Philips plays an active role in the development of international EMF and safety standards, enabling Philips to anticipate further developments in standardization for early integration in its products.