Base System Functions - Hitachi CMU Series User Manual

(3) To change the "Connection status" to ONLINE, click the
to open the [Communication type] window, specify the connection destination, and then
click the OK
To make a connection using the CMU, click the [Ethernet] and enter an IP address.
When a both ST.No.U/L rotary switches have been set to F, the default IP address
"192.192.192.1" is used.
(4) Click the ONLINE
After setting in the [Communication type] window, a session of communication
with the CMU starts to collect [[S10V] S10BASE] window display information. If
the CMU is inactive or there is an invalid setting of communications information,
the [[S10V] S10BASE] window is displayed in online state after a communication
timeout is detected. Depending on the setting of the communication type, the
communication timeout may take 2 to 3 minutes to detect.
Then, click the button corresponding to the function of your choosing.
Closing the system
Click or the
×

4.2.2 Base System functions

Base System function list
A listing of the Base System functions pertaining to the CMU can be fond in Table 4-1, "Base
System Function List." For information on additional functions, refer to "USER'S
MANUAL BASIC MODULE (Manual number SVE-1-100)."
The correspondence between the [[S10V] S10BASE] window (Figure 4-1) and the Base
System function list (Table 4-1) is given on the next page.
button.
button to connect to the PCs.
NOTICE
Close button in the [[S10V] S10BASE] window.
4-9
4 OPERATION
Change Connection button