72
Connecting the control cables
Lead the cable through the control cable entry (1).
Connect the control cables as described below. Connect the conductors to the
appropriate detachable terminals of the RMIO board [refer to chapter
and I/O board
Terminals
Frame sizes R2 to R4
The control cable connection terminals are
exposed when the control panel mounting platform
is turned aside by pulling this knob. Be careful, do
not use excess force when pulling.
Terminal for optional Prevention of
unexpected start-up (+Q950) or optional
Safe torque off (+Q967) function.
Connect the external AGPS or ASTO
board here. See page
I/O cables: Ground the
control cable shields in the
holes with screws. See
section
360 degrees
grounding.
Electrical installation
(RMIO)]. Tighten the screws to secure the connection.
77
or 83.
Detachable connection terminals (pull up)
X39 for control panel cable
X41
1
Motor control
Option module 1
Option module 2
DDCS communication
option module 3:
RDCO
Place the warning
sticker here