Commissioning A Camera (Smart Eth Gateway Networking Scenario); Commissioning Ipc6325 Cameras - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
6.5.3 Commissioning a Camera (Smart ETH Gateway Networking
Scenario)

6.5.3.1 Commissioning IPC6325 Cameras

Prerequisites



Context




Table 6-22 IP addresses planning
Device
Camera
VCN
Procedure
Step 1 Log in to the camera web page and enable ONVIF.
1.
2.
Issue 06 (2020-04-22)
If multiple cameras are accessed, retain the connection of one camera and disconnect
connections from other cameras. After commissioning the connected camera,
commission other cameras in the same way.
The camera has connected to the smart ETH gateway and the smart ETH gateway
communicates properly with the ECC800-Pro.
The camera software version is later than V500R019C30.
Before commissioning the IPC6325 camera, set the IP address for the IPC6325 camera
based on customer requirements.
Configure the camera/VCN internal IP address and the IP address of the LAN port on the
ECC800-Pro in the same network segment.
Configure the camera/VCN internal IP address and the IP address of the WAN_1 port on
the ECC800-Pro in the same network.
Set the internal and external IP addresses as planned by the customer. The following IP
addresses are just examples.
Internal IP Address
Example: 192.168.248.50; range:
192.168.248.50–192.168.248.199
Example: 192.168.248.51; range:
192.168.248.50–192.168.248.199
Remove the network cables connecting the smart ETH gateway to the LAN1 and LAN2
ports on the ECC800-Pro.
Use a network cable to connect the PC to POE port on the smart ETH gateway. Then, set
the local IP address of the PC to 192.168.0.11.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
External IP Address
Camera external IP
address
NOTE
The 192.168.246.X
network segment cannot be
set.
VCN external IP address
NOTE
The 192.168.246.X
network segment cannot be
set.
134