Utility Control Assign Function - Yamaha AN1x Owner's Manual

Step Sequencer Event
Control
The Step Sequencer's Ctrl No (Control Number)
parameter lets you determine the type of MIDI Control
Change which can be output upon sequencer play.
Once the Control Number is set, the Control Change
event is selected with Knob Event parameter
[UP/DOWN] and the value to be output via each step
is edited with the CONTROL knobs. For more
information, see page 91.
Knob Pattern
Event 1-8 / 9 -16 Step Hold Bank No
Utility Control Assign
Function
Control parameters in the UTILITY SETUP menu let you
designate the type of Control Change messages which can
be controlled by the [MODULATION] wheel, each of the
eight CONTROL knobs, the [RIBBON] controller (X-axis
and Z-axis), etc., by assigning Control Change numbers to
specific "Device" controllers. For more information, see
page 95.
System MIDI
Mstr Tune Kbd Trans Kbd Vel Tx Ch Rx Ch
SEQ SEQ
Base Unit Length LoopType Ctrl No Store EDIT /SETUP
Ctrl UTILITY
DeviceNo Local BulkDump Device Ctrl No SETUP
Based on settings in the Control Assign function as well as
in the Control Matrix, you can use a single controller to
control one parameter of the internal tone generator and
another parameter of an external MIDI device, both at the
same time. It also lets you determine which device (MW,
FC, etc.) to use for Scene Control (see page 20).
Controllers which can be assigned using the UTILITY
SETUP Control function:
MW — Modulation Wheel
FV — Foot Volume
FC — Foot Controller
FS — Footswitch
RbnX — Ribbon Controller X-axis
RbnZ — Ribbon Controller Z-axis
Knob1~8 — Assign group knobs 1 ~ 8
SCENE — Scene Control controller
Between the Control Assign function (system) knob
assignments and Control Matrix (voice) knob assignments,
you can configure a monster knob control system where
each knob simultaneously controls either the same Control
Change parameter for the internal tone generator as for
an external tone generator, or different parameters for the
internal and external tone generator.
AN1x Tone Generator
VOICE SCENE SETUP
Control Matrix
UTILITY SETUP
Control CC
For more information about each parameter, see the separate Data List book. For
information about the procedure for assigning controllers, see page 95.
50
MIDI IN
MIDI OUT