Selecting The Actual Signals Display - ABB ACS5000 User Manual

If no key is actuated within one minute (an exception from this is the fault
memory display), the CDP control panel automatically returns to the
actual signals display from other modes.
Actual values
For the complete list of selectable actual signals, see
"Appendix G – Signal and parameter table".
The actual values are organized in groups.
Group
Group 01
Group 02
Group 03
Group 04
Group 05
Group 06
Group 07
Group 08
Group 09
Fault memory
The fault memory display provides information on the 64 most recent
fault events that occurred in the drive. It displays the name of the fault
and the time it occurred. For instructions on how to display and reset the
fault memory, see "9.2.2.7 Displaying and resetting an active fault"
on page 148.
When the drive generates a fault or alarm, the corresponding message
displays immediately.
Changing from the fault memory display to other modes is possible
without resetting the fault first. If no key is actuated, the fault or alarm
message displays as long as the fault is active.
9.2.2.2

Selecting the actual signals display

To select the actual signals display, press the ACT key.
3BHS799208 E01 REV E
Description
Measured or calculated motor values
Measured or calculated drive values
Reference values
Status signals of S800 I/O system
Communication link and MCB status signals
Software version, drive and motor nominal values
Control words
Status words
Fault and alarm words
ACT PAR FUNC DRIVE
I 0
ACS5000 WATER-COOLED USER MANUAL
1 L -> 600.0 rpm
StateINU ReadyOn
MOTOR SP 0.00 rpm
POWER 0.0 kW
09 CDP CONTROL PANEL
143/186