Using An Electrostatic Wrist Strap - Dell EqualLogic PS6010 Hardware Maintenance

PS6010 Hardware Maintenance
• Temperature exceeds upper or lower limit.
• Control module cache has lost data.
• A cooling module is not installed.
• Both fans on a cooling module have failed.
• Cache battery temperature is too high to charge battery.
• NVRAM coin cell battery failed.
• Cache contains data that does not belong to any of the installed disk drives.
• More than one valid RAID set exists in array.
• Control modules are different models.
• A critical hardware component has failed.
• Operations panel failed or not installed.
• Storage enclosure processor that monitors array components has experienced
a failure.

Using an Electrostatic Wrist Strap

When handling the array chassis, disk drives, or control modules, you must use an
electrostatic protection device to prevent electrostatic discharge.
An electrostatic wrist strap is included in the shipping box.
To use the wrist strap:
1. Connect the steel snap on the coil cord to the stud on the elastic band. See
Figure 1-5.
Basic Array Information
1–5