Initializing The Hba Setting - Fujitsu PRIMEQUEST 2000 Series Manual

Settings on the Fibre Channel Card (8Gbps FC Card)

2.1.5 Initializing the HBA setting

Restore the HBA setting to the default state.
Remarks
An HBA that has just been shipped from the factory has initialized settings and does not require the work below.
Perform this work to initialize them again.
1. Select [Set Emulex Adapter to Default Settings], and then press the [Enter] key.
FIGURE 2.10 Emulex Adapter Configuration Main Menu
2. The [Set Emulex Adapter to Default Settings] screen appears. Select [Set Adapter Defaults], and then press the
[Enter] key.
FIGURE 2.11 Set Emulex Adapter to Default Setting
C122-E206-04EN
20