X200-X205 Drive-Cliq Interfaces - Siemens SINAMICS S120 Combi Equipment Manual

S120 Combi Power Modules
3.3 Interface description
NOTICE
The function of the EP terminals is only available when Safety Integrated Basic Functions
are enabled.
Note
The temperature sensor input is not needed if the motors feature an integrated DRIVE-CLiQ
interface or if temperature values are detected by means of a different module (SMC, SME).
3.3.8

X200-X205 DRIVE-CLiQ interfaces

Table 3- 11 DRIVE-CLiQ interfaces X200-X205
PIN
1
2
3
4
5
6
7
8
A
B
Connector type: RJ45 socket
DRIVE-CLiQ port rubber plug included in the scope of delivery;
rubber plug (50 pieces) Order number: 6SL3066-4CA00-0AA0
Note
DRIVE-CLiQ interface X204
For 3 axes Power Modules of the S120 Combi, there is no DRIVE-CLiQ interface X204.
Note
Inserting/removing the DRIVE-CLiQ port rubber plug
The rubber plugs must always be inserted in the DRIVE-CLiQ ports that are not required as
the final step.
If it is necessary to remove the rubber plugs, then we recommend that the guiding frame is
disassembled (Torx, slotted screw). As an alternative to disassembling the guiding frame,
flat-nosed pliers can be used to remove the rubber plug.
82
Signal name
TXP
TXN
RXP
NC
NC
RXN
NC
NC
+ (24 V)
M (0 V)
Technical specifications
Transmit data +
Transmit data -
Receive data +
Receive data -
Power supply
Electronics ground
Manual, Edition 05.2010, 6SL3097-4AV00-0BP0
SINAMICS S120 Combi