Align Plane (Cycle998) - Siemens SINUMERIK 840D sl Programming Manual

ShopTurn program
Parameter
Y
Z
List of the result parameters
The measuring variant "Outer circle segment" provides the following result parameters:
Table 3-25
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [16]
_OVR [17]
_OVR [18]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 342).
3.3.19 3D - align plane (CYCLE998)
Function
This measuring variant can be used to determine and correct the angular position of a three-
dimensional inclined plane on a workpiece by measuring three points. The angles are in
relation to the rotation around the axes of the active plane G17 to G19.
The same requirements as for the simple angle measurement apply, see measuring variant
Align edge (Page 134).
Additional data is required for the setpoint specification of the 2nd angle. A correction is made
in the zero offset in the rotary components (rotation) of the specified work offset (WO).
The translatory components of the WO remain unchanged, and should be corrected in a
subsequent measurement (e.g. set edge, corner).
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Description
Start point Y of the measurement
Start point Z of the measurement
"Outer circle segment" result parameters
Description
Circle segment diameter setpoint
Center point setpoint in the 1st axis of the plane
Center point setpoint in the 2nd axis of the plane
Circle segment diameter actual value
Center point actual value in the 1st axis of the plane
Center point actual value in the 2nd axis of the plane
Circle segment diameter difference
Center point difference in the 1st axis of the plane
Center point difference in the 2nd axis of the plane
D number or WO number
Measuring cycle number
Measuring variant
Tool name
Measuring variants
3.3 Measure workpiece (milling)
Unit
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
195