GE Hydran 201i Instruction Manual page 234

Set-up Lost ON
Soft WatchDog
Sp Span chg
STempAlr Ack
STempAlr H chg
STempAlr H ON
STempAlr HH chg
STempAlr HH ON
STempAlr L chg
STempAlr L ON
STempAlr LL chg
STempAlr LL ON
STempDelay chg
STemp H OFF
STemp HH OFF
STemp L OFF
STemp LL OFF
STempSetP chg
SystemCalib
TDM Mode chg
Unit in Service
Watchdog
Page 234
Setup lost alarm turned on
Reset of Hydran 201Ti induced by the software watchdog
Modification of the sensor temperature set point's range
Sensor temperature fail alarm has been acknowledged
Modification of the sensor temperature High alarm's set point
Sensor temperature High alarm turned on
Modification of the sensor temperature High-High alarm's set
point
Sensor temperature High-High alarm turned on
Modification of the sensor temperature Low alarm's set point
Sensor temperature Low alarm turned on
Modification of the sensor temperature Low-Low alarm's set point
Sensor temperature Low-Low alarm turned on
Modification of the sensor temperature alarm's delay
Sensor temperature High alarm turned off
Sensor temperature High-High alarm turned off
Sensor temperature Low alarm turned off
Sensor temperature Low-Low alarm turned off
Modification of the sensor temperature set point
Calibration of Hydran 201Ti
Modification of the TDM signal's operating mode
Hydran 201Ti back in service after the battery was disconnected
Reset of Hydran 201Ti induced by the hardware watchdog
Hydran* 201i Instruction Manual
MA-033 Rev. 14.0, 12-Nov-18