Installing Batteries In The Remote Control; Remote Control Operation Range - Pioneer L40S3D13N Instruction Manual

2
Preparation

Installing Batteries in the Remote Control

GB
1. Slide the battery cover to open the battery
compartment of the remote control.
2. Insert two AAA size batteries. Make sure the (+)
and ( - ) ends of the batteries match the (+) and
( - ) ends indicated in the battery compartment.
3. Slide the battery cover back onto the remote
control to close the battery compartment.
Handling the Batteries
• Improper or incorrect use of batteries may cause
corrosion or battery leakage, which could cause fire,
personal injury or damage to property.
• Only use the battery type indicated in this manual.
• When the batteries are exhausted, the remote will
not function. Replace both batteries at the same time
with new ones.
• Do not install new batteries with used ones and do
not mix different types of batteries.
• Do not dispose of used batteries as domestic waste.
Dispose of them in accordance with local regulations.

Remote Control Operation Range

Point the remote control at the TV no more than 5 metres from the
remote control sensor on the TV and within 60° in front of the TV.
The operating distance may vary depending on the brightness of the
room.
12
Handling the Remote Control
• Take care of your fingernails when you press and hold
the battery release tab.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight
or near sources of excessive heat.
• Remove the battery from the remote control when
not in use for a long period of time, as it could
cause corrosion or battery leakage and may result
in physical injury and/or property damage including
fire.
30° 30°
5M