Table of Contents
Advertisement
Problem
MANUALLY PARK SHUTTLE
MISSING STITCHES
MOTOR CONTROLLER NOT
READY
OPERATOR MAINTENANCE
REBOOT THE MACHINE
REMOVE SET FROM FOLD
AREA
REMOVE SET - GATHERING
AREA
REMOVE SET - STITCH AREA
Rotate axis moving
ROTATE - No comms
Cause
The shuttle is not parked cor-
rectly. Open the folder cover
and move the shuttle to the
park position. Close the folder
cover. The shuttle will reset.
When the message list is
clear, continue operation.
The machine has detected
missed stitches. Check if the
stitch wire is jammed or if the
stitch wire spool is empty.
The drive motor controller is
not ready. If the problem con-
tinues, contact your service
engineer.
The machine needs routine
maintenance by the operator.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
Open the folder cover and re-
move the set.
Open the gathering area and
remove the sheets.
Open the folder cover and re-
move the set.
The rotate axis is moving. This
message clears when the ad-
justment is complete.
If the message does not clear,
touch ADVANCED > RE REF.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
Chapter 6 - Error Conditions, Problems and Solutions
Error Messages
Solution
Manually park the Shuttle
See
on page 102
See
Clear a Stitch-wire Jam on
page 95
Install New Stitch Wire on
See
page 123
Operator Maintenance on
See
page 110
See
Jam in the Stitch Area on
page 89
4
81
Advertisement
Table of Contents
